Fishing traps, for octopus trapping, crabs, eels, shrimp


External Action

LONG INF.=450mm         LONG SUP.= 380 mm

WIDTH INF.=380 mm      WIDTH SUP.= 240 mm

HIGH=200mm

Exploded view of the model..

Consists of 4 parts: top, bottom cover, bait and dummy for fitting ballast(cement)the hairpieces have different height , To offer more or less ballast. Each unit includes two hairpieces according to le piece, the trap i could have from 3 kg to 8 kg weight approx.

Special entry for catches of octopus, with receptacle for bait and side door for draining catches

nestable

You can clip the top, allowing cheaper in the shipping costs. By sending the upper parts and the bottom piece separately and once on target unirian and terminaria to mount the trap The lower parts, above together with the hairpieces for ballast, allow in 1 cubic meter may be transported 50 units.

The assembling the parts, is by iron rods that are interwoven using a kind of rings that attach the top of the bottom.

Before that union, there are a couple of simple processes, as would be the place the cement and the placement of the rope.

The first process would be to prepare the ballast of NASA. We need the hairpieces and bottom. Are placed the hairpieces on the ground full of mortar.

With the top is placed on the hairpieces in areas predestined.

Emphasize that it is important to make a good mixture to have good hardness once dry

Populates the hairpieces with the mixing of mortar, this, to be s˛lida, it is best to work with sandy of coarse grains.

The proporci˛n serious a portion of cement, two portions of sand with a handful of fiber glass for better hardness. The density of the mixture should be very manageable.

Once it is placed the ballast , we let it dry for a day or two

The workpiece is placed below, in a way that the ballast go inside the trap. The function of this dummy is to create the form it takes the ballast on the NASA, offering the necessary weight to develop its function

Once the position of the workpiece, the next step is to fill up to leave the ballast to the same level as the base.

Ensure that the channels where will the iron, not deal with remains of the mortar.

It is left to dry long enough and we can go to put yÓ rope and irons

So would be the basis of the trap, once that the mortar is dry. To proceed to the following processes:

Put the rope; we need breaststroke and average of rope diameter of 10mm.

Union of the base with the top part; we need three iron rods diÓm, 10mm: two of 420mm and a 320mm long

The process of the rope starts , once cut and the tips burned , are inserted through the holes in the top part for this function. The tips are re-engage in the first loops in the lower part, continuing to the lifting eyes on the top part, re-engage the ends to the following the lower part eyes and performed a few knots in the ends of the rope. Being subject by the rope the two parts,

The lower and the upper part. The notches for meter rods must match

The process of putting the irons, we have the problem that the rod is go entrecolando by the shackles of the parts. As it appears in the image

This model you can place a side door for draining of catches. This door is optional, according to a decision of the user.

We can send you the basic model and the door, so that the user would place, reducing costs

We can send it with the side door placed

Basic model without the side door, with which would have to take catches by where they enter the catch.

Finally we still fit the hooks on the side door ,(if the leads) and in the door where the bait, going in this door should fit two flanges on the part of the hinges. As you can see in the photos.

Normally we always send a trap totally topped so that it can fit the other


VOLVER


Nasas Moreira s.l. les agradece su visita